Symtech ATF 1 - Manual (Page 7)

6
CONTROL PANEL LAYOUT
Power Saving Mode
The ATF1has a power saving mode that protects
and prevents operation of the unit under 11volts DC.
LCD readouts will display “LO BAt” and the
keypad will be non-functional until the unit is
connected to a 12volt DC supply and main power is
switched off and then back on.
On Board Battery
The ATF1on board battery is very similar to any
other cordless tool with a battery. The more it is
slowly charged at a low rate the better the charge
and longer the battery life.
Charging the on board battery after every three to
four transmission flush services with the on board
battery charger will greatly extend the life of the
battery.
1. NEW Fluid TankReadings
2. USED Fluid Tank Readings
3. INCREASE Fluid Amount
4. DECREASE Fluid Amount
5. POWER ON LED
6. STOP System Button
7. QUARTS / LITERS Mode
8. COOLER Line Mode
9. FLUID EXCHANGE Start
10. Reverse Polarity Warning
11. Process READY Indicator
12. DIPSTICK Mode
13. EMPTY NEW Tank Function
14. LOW Fluid Level Warning
15. DRAIN PAN Function
16. RESUME REFILL Function
17. REMOVE FLUID Function
18. ADD FLUID Function
19. EMPTY USED Tank Fluid
Function
20. HIGH Fluid Level Warning
1
3 4
5
6 7
8
9
10
12
13
14
15
16
17
18
19
2
11
20