Symtech ATF 1 - Manual (Page 14)

13
6)
The RESUME REFILL LED will light, at this time step “a” or “b” listed below, can be
performed:
a)
The exchange process is momentarily stopped here and the transmission pan is
removed to change transmission filter/screen or perform other transmission services.
Upon completion of filter change or other services, continue with step “b” below.
OR,
b)
Exchange can continue by depressing RESUME REFILL button and NEW fluid, equal
to the amount extracted, is pumped into vehicle. NEW fluid display will decrease from
the amount extracted down to 0 and the USED fluid display is blanked. This step is
complete when RESUME REFILL LED turns off, READY light turns on, and Alarm
sounds.
7)
DIPSTICK LED will begin flashing, indicating that vehicle must be started at this time. After
starting vehicle, press DIPSTICK button, a twenty (20) second timer will begin to allow new
and used fluid in transmission to intermix.
After twenty second time period has elapsed, a repeated process will begin where 1.6 quarts is
extracted and automatically replaced until total amount of fluid selected for exchange has been
achieved. After each extraction and addition, a ten (10) second delay will occur to inter mix
new and used fluid for most efficient exchange. Exchange is complete when alarm sounds and
DIPSTICK LED is off. (The vehicle will remain running throughout this entire process)
9)
After exchange has been completed, check vehicle’s transmission fluid level. Add or extract
fluid to achieve proper fluid level by selecting DIPSTICK mode then depressing the
appropriate ADD FLUID or REMOVE FLUID buttons on the control panel. Additions are
displayed in NEW fluid display while removals are displayed in USED fluid display. This
amount can be increased or decreased using the “ + ” or “ - “ buttons on the control panel. The
desired amount will be extracted or added upon depressing ADD FLUID or REMOVE FLUID
button the second time. Repeat this procedure until the proper level is maintained.
NOTE: If NEW fluid tank does not have enough fluid to perform the ADD FLUID function or
USED fluid tank does not have enough capacity to perform the REMOVE FLUID
function, the appropriate LED will flash and beep indicating LOW TANK LEVEL in.
EW tank and/or HIGH TANK LEVEL in USED tank. Take the appropriate action to
correct and then repeat Step 9. See page 13 for instructions
Dipstick Exchange Process, Easy Reference
**NOTE: VEHICLE TRANSMISSION FLUID SHOULD BE AT OPERATING TEMPERATURE PRIOR
TO PERFORMING ANY SERVICE WITH THE ATF1.
**NOTE: : THE ON BOARD BATTERY SHOULD BE AT FULL CHARGE FOR MOST
EFFICIENT FLUID EXCHANGE SERVICE, make it a habit to plug the on board battery
charger into a 110 volt service outlet after every 3 to 4 fluid services for efficiency and
extended battery life.
Preparation:
1.
Connect red and black hoses of unit to matching color male connectors of dipstick flow control
valve.
2.
Connect dipstick extraction wand to female coupler of control valve.
Operation:
3.
Insert Dipstick wand into transmission fluid fill tube.
4. Connect ATF1to vehicle battery . Turn on Main Power.