Torbal AGZN200 - Manual (Page 17)

Instruction Manual - TORBAL AGZN Series
3. Commands “AUT ON”, “AUT OFF”, and “AUT SET” will be displayed sequentially.
4. Press the T key when command “AUT SET” is displayed.
5. Default AZSM setting will be displayed followed by the “OUT” command. To exit AZSM configuration,
press the T key when “OUT” is displayed. To change AZSM range, press the T key when the current AZSM
value is displayed (i.e., 2.0).
17
To Exit To Change
6. After the T key is pressed, in order to set a new AZSM range a dash will be displayed indicating a new AZSM
value between 0.1d and 5d should be entered.
7. To enter a new AZSM value, use the following keys: the C key to increment a digit, the T key to accept and
go to the next digit, the P key to insert a decimal, and MENU to accept the entire setting.