Conceptronic C300BRS4 User Manual
Page 37
Conceptronic C300BRS4
User Manual
37
PPPoE
Follow the instructions below to configure the Router to use a PPPoE for the Internet connection.
Make sure you have all the necessary information before you configure the WAN connection.
WAN Settings window for PPPoE
To set up a PPPoE connection:
1. If not already selected, click the PPPoE radio button at the top of the window.
2. Under the PPPoE Settings heading, type the User Name and Password used for your ADSL
account. A typical User Name will be in the form [email protected]. The Password may be
assigned to you by your ISP or you may have selected it when you set up the account with your
ISP.
3. Leave the MTU value at the default setting (default = 1492) unless you have specific reasons
to change this (see table below).
4. Typically the globally IP settings (i.e. IP address for the WAN interface) for a PPPoE
connection will use Dynamic IP assignment from the ISP. Some accounts may be assigned a
specific global IP address.