Conceptronic C300BRS4 User Manual
Page 38
Conceptronic C300BRS4
User Manual
38
5. Choose the desired Connect mode select setting. Select from: Always on, Manual, or Connect
on demand. Most users will want to choose the default connection setting, Always on.
6. When you are satisfied that all the WAN settings are configured correctly, click on the Apply
button.
7. The new settings must be saved and the Router must be restarted for the settings to go into
effect. To save and reboot the Router, click on the Tools directory tab and then click the
System button. In the System Settings window, click the Save button under Save Settings to
Local Hard Drive and then click the Reboot button under Reboot the CONCEPTRONIC
C300BRS4.
8. The Router will save the new settings and restart. Upon restarting the Router will
automatically establish the WAN connection.
Additional settings for PPPoE/PPPoA connections:
PPPoE/PPPoA Parameters
Description
User Name
For PPP connections, a User Name and Password are used to identify
and verify your account to the ISP. Enter the User Name for your ADSL
service account. User names and passwords are case-sensitive, so
enter this information exactly as given to you by your ISP.
Password
Together with the User Name, this is used to verify your account to
the ISP. Enter the Password exactly as given to you by your ISP.
MTU
The Maximum Transmission Unit size may be changed if you want to
optimize efficiency for uploading data through the WAN interface. The
default setting (1492 bytes) should be suitable for most users. Some
user may want to adjust the setting to optimize performance for
wireless traffic or when low latency is desired (such as with Internet
gaming). It is highly recommended that the user research how
adjusting the MTU may affect network traffic for better or worse.
IP Address
If you have selected the Static PPPoE option, type in the global IP
address used for your WAN interface. Your ISP should provide this IP
address to you.
MAC Address
To use the Clone MAC Address feature, enter a MAC address in this
field and then click the Clone MAC Address button.
Primary DNS
Enter the Primary DNS Address. This information should be provided to
you by your Internet Service Provider.
Maximum Idle Time
A value of 0 means that the PPP connection will remain connected. If
your network account is billed according to the amount of time the
Router is actually connected to the Internet, enter an appropriate Idle
Time value (in minutes). This will disconnect the Router after the
WAN connection has been idle for the amount of time specified.