Wine Guardian Ducted Split Wine Cellar Cooling Systems (WGS175) - Manual - Manual (Page 45)

47
Mounting the Remote Interface Controller
1.
Disconnect the communication cable from the
side of the Wine Guardian unit and the Remote Interface
Controller.
a) Install the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b) Mount the remote interface controller on a solid
surface away from doors, corners, air outlets, drafts
or heat generating equipment. Do not mount the Remote
Interface Controller directly on an outside wall or wall
adjacent to a boiler room.
2.Remove the back plate of the controller and mark the
mounting points at the desired location. (Fig. 2)
a) Mark the location of the communication cable
connection as this area will require sufficient clearance
for instance, a 3.8cm hole in the wall for flush mounting
of the back plate. (Fig. 3)
3. Drill two (2) .32cm holes and insert anchors
(provided) within the mounting surface. Anchors may
not be required if securing to a wall stud or racking
system
Fig. 2
Fig. 3
Fig. 1