B&C Technologies SP Series Commercial - Manual (Page 18)

Before servicing any equipment, make certain it is disconnected from the electrical
power source. Never allow operation of the machine when any safety device is
malfunctioning. Never bypass safety devices.
Never insert hands or objects into basket until it has completely stopped. Doing
so could result in serious injury.
1. When the washer is energized electrically and in operation, the loading door must be locked
in the closed position. Verify this by attempting to open the loading door when the machine
is operating. If necessary, check the door safety interlock and sensors for proper operation.
Consult the service manual, or call a qualified service technician if necessary.
2. When the washers loading door is open, it should not be possible to start the machine. Verify
this by attempting to start the washer with the door open. Also, close the door without
locking it and verify that it is not possible to start the machine with the door not locked. If
necessary, check the door lock sensors for proper operation,. Consult the service manual, or
call a qualified service technician. If additional information is required, contact your local
distributor or call the manufacturer of the machine.
• To provide personal safety and keep the machine in proper working order, follow all main-
tenance and safety procedures presented in this manual. If questions regarding safety arise.
Contact the factory immediately.
• Use factory authorized spare parts to avoid safety hazards.
4.2.1 Operator Safety
To ensure the safety of machine operators the following maintenance checks must be performed
daily.
1. Prior to operating the machine, verify that all warning signs are present and legible. Missing
or illegible signs must be replaced immediately. Make certain that spares are available.
2. Check door interlock before starting operation of the machine, see safety check list.
3. Do not attempt to operate the machine if any of the following conditions are present:
(a) The door does not remain securely locked during the entire cycle.
(b) Excessively high water level is evident.
(c) Machine is not connected to a properly grounded circuit.
Do not bypass any safety devices in the machine.
14