B&C Technologies SP Series Commercial - Manual (Page 41)

Undiluted chemicals dripping can damage the machine. Therefore, all chemical supply dis-
penser pumps should be mounted below the washers injection point.
All dispenser tubing
should also run below the injection point. Loops do not prevent drips if these instructions are not
followed. Failure to follow these instructions could damage the machine and void the warranty.
Figure 4.16: External Chemical Supply Connection Detail
4.11.1 Chemical Connection
The supply compartment on the B&C SP models is located on the front of the machine. Supply
cups can be accessed by opening the dispenser lid. The supply cups can be removed and filled as
desired. Supply compartments are numbered 1,2,3,4 and 5 from the left of the machine to the right
for the optional 5 cup system.
The standard single cup supply will flush when Detergent 1 is programmed in the EL6. The
optional five cup supply dispenser will flush each cup when Detergent 1 through Detergent 5 is
programmed. The programmed chemical signal also appears as a 24VAC signal at the external
chemical terminal strip for the duration of each programmed signal.
External supply connections for the B&C SP washer-extractors with the Stainless Steel supply box
are located on rear of the machine at the vacuum breaker. Hose connections should be made via
the threaded connectors. See figure 4.17 on page 39.
1. Remove plugs from base. See figure.
37