Hit Products RainPro Expandable - Manual (Page 10)

ESTABLISHING INDIVIDUAL STATION RUN TIMES
This is the setting for establishing how long each
independent “valve” or “station” will be on to irrigate.
Each station will come on in numeric sequence for
this duration as set for each Station Run Time.
1. Rotate dial to the “Station Run Times” position.
2. Choose program A, B, or C. To change
program from existing program, push the
“PGM” button.
3. Press the + or - button to increase or decrease
the length of time you desire for this specific
station (valve) to be “ON” each time this valve
is activated on this specific program.
4. Press the →button to go to the next station.
5. Repeat steps 3 and 4 for each station that is to
be active on each specific program. For
stations/valves that are inactive on a specific
program, put “Station Run Times at “0:00”.
6. Each individual “Station Run Times” can range
from 1 minute to 6 hours in duration.
7. Rotate dial to “RUN” to enter new data into the
controller.
Note: Water Budget should be set at 100% when
programming station/valve “Run Times”.
SETTING WATERING SCHEDULE/CALENDAR OF “ON”
DAYS
1. Rotate the dial to “Calendar/Schedule.”
2. Choose program A, B or C. To change program
from existing program, push the PRG button.
10