Hit Products RainPro Expandable - Manual (Page 3)

MOUNTING THE RAIN PRO CONTROLLER
Indoor
1. Locate the controller within 5 feet of a standard
electrical outlet that provides continuous,
uninterrupted power. Do not install controller within 15
feet of a pump, pump start relay or any high power
junction boxes or electrical motors.
2. Choose desired location and install one screw for top
keyhole into wall. Use screw anchors if attaching to
drywall or masonry.
3. Hang controller on this screw. Mark wall for two
remaining screws holes and install screws accordingly
to secure controller to the wall. Use screws anchors if
attaching to drywall or masonry. Do not over tighten.
Outdoor
1. Select desired location that is at least 15 feet away
from a pump, pump start relay or any high voltage
junction boxes or electric motors.
2. Choose desired location and install one screw for top
keyhole into wall. Use screw anchors if attaching to
drywall or masonry.
3. Hang controller on this screw. Mark wall for two
remaining screw holes and install screws accordingly
to secure controller to wall. Use screws anchors if
attaching to drywall or masonry. Do not over tighten.
Note: The controller should be hard wired to the transformer
by a qualified electrical technician. Use approved GFI device
and use proper grounding techniques utilizing the green wire
lead from the transformer. Install as per all local codes. This
will help assure safety as well as performance and reliability
of the controller.
3