Hit Products RainPro Expandable User Manual
Page 17
PROGRAMMABLE PAUSE BETWEEN STATIONS
1. Rotate dial to “RUN” position.
2. While depressing the – button, simultaneously rotate
dial to “Station Run Times” position.
3. Leave dial in this position, remove finger from the –
button. Delay time will be flashing.
4. Push the + or – buttons to select the desired delay
time between each station operation. Range of
programmable delay is 1 second to 4:00 (four hours
and zero minutes).
5. Rotate dial back to the “RUN” position to enter this
new data in controller.
NOTE: Pump Start/Master Valve circuit will not operate
during “PAUSE”.
RE-SETTING OR ERASING CONTROLLER MEMORY
To reset the clock and calendar, push the “RESET” button
located in the recessed hole on the panel back. This will
reset the clock to 12:00 a.m. and the calendar to 1/1/2006.
Program information will not be affected.
To erase all programming information, turn the dial to the
“CURRENT DATE/TIME” position, then press the minus (-)
the right arrow (→) and PRG buttons at the same time. This
will clear all user information.
CAUTION:
This appliance is not intended for use by young children or
infirm persons without supervision.
17