Axesstel MV400 - Manual (Page 24)

23
Connecting to Data Service with USB connection
After USB driver has been installed, you must use AxessManager to configure
and connect the Modem to the network. Please refer to AxessManager
Operational Guide chapter for detailed instructions. Make sure the Modem
selector switch is set to USB position before attempting the connection.
Normally Windows OS will automatically detect your Modem USB connection after
you have installed AxessManager. If for some reasons Windows OS failed to
complete this task, you may need to perform the following steps after installing
AxessManager to fully configure your Modem in USB mode.
1. Verify in Network Connection window that
USB connection has been created in “Dial
up” section. The connection name is set by
your service provider (default name is
1xEvDO). You can also find the connection
name in AxessManager utility, USB
Connection Profile tab
2. If no USB connection appears in Dial up
section, go to AxessManager utility, USB
Connection Profile tab, highlight the
connection name your service provider has
created, click Edit and OK to accept the
setup. This will add the connection to the
Network Connection window.
3. In very rare cases, Windows OS may
associate the wrong modem to your Dial up
connection. To verify, right click on the Dial
up connection name in step 1 above and
select Properties. You should see the
Axesstel USB Modem selected and the
correct dial number entered. If not, update
the fields with correct value.