CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 15)

EdgeAccess Universal Chassis System
Chapter 3
User Operation
This chapter describes the hardware features and functions of the L357.
3.1 L357 Functions and Power Up
Each L357 requires a host for power. During the initial power-up sequence, all LEDs light amber.
When start-up is complete, the setup and installation are correct, and data is transmitting normally
across the link, the STA LED lights green and the LNK/Rx and Tx LEDs for both ports light green or
blink green when they transmit or receive data. See Table 3.
3.2 Front Panel LEDs
The LEDs on the front panel show the system and port conditions. The STA LED shows the link
condition. The LNK/Rx and Tx LEDs show the conditions on the User and Extension Ports and can
be used as an aid when troubleshooting a fault. Table 3 shows the LED states for various conditions.
In the UCS 1000 and 1001, a BAM holds up to two L357s. On the BAM, the STA LED lights green
if either L357 is operating normally. If both L357s are in error conditions, the BAM STA LED lights
amber.
Table 3. L357 LEDs
LED Status Description
Off No power
Green Normal operation
Amber System self-test
Amber blinking Downloading file
STA
Red Major alarm
Off SBMC is disabled
Green SBMC is enabled
Amber System self-test
CFG
Red Configuration error
LNK/Rx (User Port) Off No link
Green Link Established
Green blinking Receiving activity
Amber System self-test
L357 Gigabit Ethernet Service Unit 3-1