CANOGA PERKINS L357 Gigabit Ethernet Service Unit - Manual (Page 27)

EdgeAccess Universal Chassis System
4.5.2 Functional Configuration Screen
The Functional Configuration report and menu provides information about the hardware, with options
to set software control. You can only view the options for the Remote module, but you can set
options for the Local L357 to work with the Remote module. For details about how RMTF, LLE, and
LLF interact, see " Section 3.3" on page 3-3. Two reported hardware switch functions depend on the
type of module:
• An L357 with a UTP User port ignores the LLE User settings.
• An L357 with a fiber User port ignores the User Speed/Duplex settings.
In addition, a system that supports 1000 BASE UTP ports allows only one port set to Master; all
others must be set to Slave.
To access the Functional Configuration screen, see Figure 14 and Table 5 and follow these steps:
1. From the Main Menu, type 1 , "System Configuration," and press <Enter>. The System
Configuration menu appears.
2. From the System Configuration menu type 2 , "Functional Configuration," and press <Enter>.
3. At the Functional Configuration screen, type the number for an item and press <Enter>, then
press <Space> to cycle through the options and press <Enter> to select an option for the Local
L357.
4. To return to the System Configuration menu, press <Esc>.
FUNCTIONAL CONFIGURATION
Local Remote
Chassis/Slot 4/3B 2/5
User Port Speed/Duplex 1000M/Half 1000M/Half
Switch Settings:
User Port Speed/Duplex 1000M/Full Autonegotiate
Side Band Mgmt Enabled Enabled
LLF Extension to User Disabled Disabled
LLF User to Extension Disabled Disabled
1) Configuration Option Control Hardware Hardware
2) User Port Setting 1000M/Half Autonegotiate
3) Ext Port Setting Autonegotiate Autonegotiate
4) RMTF/LLE Disabled Disabled
5) Link Loss Fwd Disabled Disabled
6) Remote Configuration
Figure 14. Functional Configuration Screen (UTP to Fiber L357)
L357 Gigabit Ethernet Service Unit 4-7