Dynon Avionics EMS-D120 Pilots Users Guide - Manual (Page 14)

Product Operation
CYCLING BETWEEN SCREENS
There are two methods for cycling between pre-defined screens: via
the menu and via hotkeys.
3-4 EMS-D120 Pilot’s User Guide
Screen Cycling Using the SCREEN LIST
Hold two seconds
Navigate to the SCREEN LIST menu by holding button six for at
least two seconds when no menu is present (see the figure to the
right). Note that if you only press button six momentarily, the display
cycles to the next screen in your screen rotation. Use the
DOWN▼/UP▲ buttons to move the caret (>). The caret denotes the
selected screen. Press GOTO► to remove the SCREEN LIST and
display the selected screen. If you wish to stay on the same screen,
you may either select your currently displayed screen with the caret
and press GOTO►, or press CANCEL.
Screen Cycling Using Hotkeys
With no menu displayed, press button one to cycle to the previous
screen in your rotation. Likewise, press button six to cycle to the
next screen in your rotation (see the figure on the next page). Cycling
via hotkeys only allows you to display screens that are in your screen
rotation. They are meant to give you quick access to the screen
configurations that are most important to you. If you wish to access
screens that are not in your rotation, use the SCREEN LIST as described above.
With no menus displayed, pressing button six for
two seconds displays the SCREEN LIST menu,
from which you may switch to, and set up, various
screen configurations.