Dynon Avionics EMS-D120 Pilots Users Guide - Manual (Page 35)

EMS Operation
EMS-D120 Pilot’s User Guide 7-3
You may configure the PRESET value using the following path: EMS > SETUP > FUEL > PRESET VALUE >
INC+/DEC- > BACK.
Reset fuel level to full: EMS > SETUP > FUEL > FULL
You may configure the FULL value using the following path: EMS > SETUP > FUEL > FULL VALUE > SEL► >
INC+/DEC- > BACK.
Note: It is necessary to calibrate the EMS Fuel Computer with the sensors for fuel level to work correctly. See the EMS-
D120 Installation Guide for more details.
Engine Leaning
Enter Lean Mode: EMS > LEAN
This puts the EGT display into lean mode, changing the numerical values for each cylinder to the format “order peaked-
temperature below peak.”
Exit Lean Mode: EMS > LEAN
This returns the EGT display to normal.
Clock Setup
Set Time: EMS > TIMES > CLOCK > SEL► > INC+/DEC- > BACK
This menu, and corresponding dialog box, allows you to set both your local time and Zulu time in 24-hour format. You
may display times in either 12-hour or 24-hour format as described in the next section. Set the local and Zulu times
independently. Highlight values using SEL►. Adjust highlighted values with INC+/DEC-. Each time a button is
pressed, the value changes by one. Hold down INC+ or DEC- to adjust values rapidly. Seconds are reset to zero when