Dynon Avionics FlightDEK-D180 Installation Guide - Manual (Page 138)

Appendix
* If an HS34 failure is detected during this condition, the EFIS “direct” audio output (tones only
is automaticall )
y re-enabled (fail-over).
test
(“DYNON AVIONICS”) on the audio output line. This allows you to verify connections and
d EMS are listed i
BARO settings UP >
re an initial pus has any
is configured by setting FIRST ACTION: ALT /
e, respectively.
knob activates the F ARO)
displays a “pop-up” window indicating the c e
value of the FIRST or BARO).
ithin 5 second -activates
up window. If there is no further action (either a
ALUE knob
op-up window
E knob
ates the second ob –
he pop-up win
e or after
e-activates the VA ow.
the value of the FIR
w indicating the cur lue. Pushing
nds of the last knob rotation closes the pop-up
chever was not chosen as FIRST ACTION) and
closes the pop-up window.
Selecting TEST VOICE OUTPUT and then pressing SEL► produces an audible voice
volume on the ground.
The possible voice alerts for both EFIS an
VALUE Knob Configuration
The VALUE knob changes the ALT and
VALUE KNOB ►.
The VALUE knob can be configured to requi
effect (REQUIRE PUSH: YES / NO).
The “default” mode of the VALUE knob
BARO to set Altimeter or Barometer mod
If REQUIRE PUSH is set to YES:
 The first push of the VALUE
and
n the table above.
and is configured from HSI SET
h before rotating the knob
IR r B
urrent mode and value. Rotating th
ST ACTION mode (ALT o
knob within 5 seconds changes the
A second push of the VALUE knob w
the VALUE knob and closes the pop-
knob push or knob rotation), the V
after 5 seconds and closes the p ACTION mode (ALT
s after rotating the knob de
automatically de-activates (times out)
.
, the knob is not rotated, a second push of the
ary mode of the VALUE kn
dow.
a knob rotation (within the 5 second
LU ind E knob and closes the pop-up w
 If, after the first push of the VALU
VALUE knob within 5 seconds activ
indicated by the mode displayed in t
 Pushing the VALUE knob a third tim
windows described above) d
If REQUIRE PUSH is set to NO:
 Rotating the VALUE knob changes
BARO) and displays a pop-up windo
the VALUE knob again within 5 seco
window.
ST ACTION mode (ALT or
rent mode and va
 Pushing the VALUE knob without first rotating it activates the secondary mode of the
VALUE knob (ALT or BARO, whi
displays a pop-up window indicating the current mode and value. Pushing the VALUE
knob again within 5 seconds of the last knob rotation
 If there is no further action (either a knob push or knob rotation) within 5 seconds, the
pop-up window automatically closes.
9-22 FlightDEK-D180 Installation Guide