Dynon Avionics FlightDEK-D180 Installation Guide - Manual (Page 91)

Autopilot Installation and Configuration
FlightDEK-D180 Installation Guide 8-7
or corner stock. Dynon recommends using 6061 T6 aluminum with a minimum thickness of
0.050” for the best balance of strength to weight. When fabricating a mounting bracket, refer to
the servo dimensions below. Be sure to leave ample room for the arm and attached linkage to
move through a complete range of motion without interference.
CAUTION: In normal operation, Dynon’s servos can reach temperatures that can be
very uncomfortable to, and perhaps cause burns to unprotected skin. Thus, servos should
be mounted in an area, or in such a manner to prevent accidental skin contact. If
mounting the servo in an exposed area is necessary, a shroud should be installed (that
doesn’t restrict ventilation) that protects against accidental skin contact with the servos.