Leica Geosystems Leica DISTO Pro - Manual (Page 36)

38 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Calculation, contd.
As soon as the measurement is done
in tracking mode, press trigger key
again briefly.
Press briefly to confirm
displayed value.
The first measured value appears
beside the corresponding number
"1". At the same time the second
side of the triangle to be measured is
marked in black with the
corresponding number "2".
Measure the second and third side of
the triangle as described.
Each of the three displayed
measured values can be
selected again with the navigation
key and corrected by a new
measurement.
After confirming the last
measurement press briefly to
start computation.
Should all results be saved to the
data memory?
Press and hold.
After saving the menu function is
terminated and the basic settings are
displayed.
Should only a certain result be used?
Select desired result with
navigation key.
Press briefly to confirm
selection.
Menu function is terminated and the
marked result displayed in basic
settings.
If desired save result to keypad or
data memory.
Triangle SH (5.2)
After measureing the basic side and
height (SH) of a triangle the menu
function computes the area of the
triangle.
After calling up this menu function,
the following is displayed:
For the first measurement the base
side and the corresponding number
"1" are marked in black.
Press briefly the change into
Pointing mode.
Align DISTO and point with laser at
the first point to be measured.
Trigger measurement. Hold
DISTO steady.
Press and hold trigger key to start
minimum tracking.
As soon as measurement is done
briefly press trigger key again.
Press briefly to confirm
displayed value.
Base length is displayed beside the
corresponding "1".
1
2
3
3.118m
0 3.118m
triangle SSS 5.1
1
2
3
0 2.379m
69.8°
0 4.003m 2
triangle SSS 5.1
triangle SH 5.2
1
2
1
2
0 3.147m
0 3.147m
triangle SH 5.2