Leica Geosystems Leica DISTO Pro - Manual (Page 44)

46 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
The arrow stands for recalling the
stack; the number beside it shows
the memory location in the stack
(1-15).
Below the current memory contents
is shown or "0.000" if the memory
location in the stack is empty.
The most recent (current) entry is
always in memory location 1, the
second to last entry in memory
location 2, etc.
Select memory key with
navigation keys or select
directly via keypad entry.
Press briefly to recall
contents.
Memory, contd.
The first memory key is displayed.
Select memory key with
navigation keys or select
directly via keypad entry
After saving a short confirmation
appears, then the basic settings.
Recall with 0 key
Press until there is an
audible beep (approx. 1 sec).
If the key if pressed for too
long the stack contents is
displayed (6.3).
Press briefly to display
contents.
After a short confirmation, basic
settings are displayed.
Stack (6.3)
The stack saves the last 15
measurements, computations or
entries automatically to a shift
register. This means the saved
values have no fixed allocation but
"shift" through the stack.
When all 15 memory locations in the
stack are occupied, each new entry
will delete /overwrite the most recent
memory location used.
Default setting: after reset the stack
is deleted (3.4)
Recall with menu
After calling up the menu function,
the following is displayed:
After a short confirmation the
memory contents is displayed in
basic settings.
The results of individual
measurements for basic
functions (Pythagoras, heights) or
computations (triangles, trapeziums,
etc.) can be recalled from the stack
and used for further calculations.
Recall with 0 key
Press and hold key for about
2 seconds until two beep
sounds are audiable.
If the key is pressed for too
short a period then the
memory key is displayed (6.2).
5.125
recall key 1-9 6.2
1
stack 6.3
1
7.891
7.891
1
stack 6.3