Leica Geosystems Leica DISTO Pro - Manual (Page 55)

57 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
If not installed and used in
accordance with the instructions,
they may cause harmful interference
to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an
experienced radio/TV technician for
help.
WARNING:
Changes or modifications not
expressly approved by Leica
Geosystems for compliance could
void the user’s authority to operate
the equipment.
Product labelling:
Precautions:
Only use equipment or accessories
recommended by Leica. They fulfill
the stringent requirements and
norms in combination with DISTO.
Keep in mind the computer
manufacturer specifications on EMC.
CAUTION:
Interference caused by
electromagnetic radiation can result
in the tolerance limits for
measurements being exceeded.
Although the DISTO meets the strict
regulations and standards which are
in force in this respect, Leica
Geosystems cannot completely
exclude the possibility that
interference may be caused to the
DISTO by very intensive
electromagnetic radiation, for
instance near radio transmitters,
walkie-talkies, diesel generators etc.
Under such conditions, check
measurement results for their
plausibility.
Electromagnetic Compatibility (EMC), contd.
WARNING:
Operating DISTO with one
end of a cable connected (e.g.
external feeder cable, interface
cable,...) can lead to exceeding the
electro-magnetic emmission of
radiation and thereby causing
interference in other instruments.
Precautions:
While operating the DISTO, cables
must be connected at both ends (e.g.
instrument/computer,...).
FCC Statement (applic. in
U.S.)
WARNING:
his equipment has been
tested and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC
Rules..
These limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. Instruments of this kind
generate high frequency and may
radiate them, too.
This device complies with part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) This device may
not cause harmful interference,
and (2) this device must accept
any interference received,
including interference that may
cause undesired operation.
PD-Z65