Leica Geosystems Leica DISTO pro /pro4a - interface manual - Manual (Page 11)

3350-RUEA Error! Style not defined.
I:\DIST\Marketing\0Temp\Doc\interfaceManual111_en.docSeite 11 von 18 Erstelldatum: 17.06.03
5 S
ET OF
C
OMMANDS IN
O
NLINE
-M
ODE
(E
XTENDED
M
ODE
)
5.1 Quit online-mode (STD or B)
Function:
Switches DISTO TM pro 4 / DISTO TM pro 4 a to offline mode
Input:
STD<cr>
or B<cr>
Output:
?<cr><lf>
or @Exxx<cr><lf>
5.2 Distance measurement (G)
Function:
Trigger single measurement with short output, like „g“
Input:
G<cr>
Output:
WI31<cr><lf>
or @Exxx<cr><lf>
5.3 Tracking (H)
Function:
Triggers continuous distance measurement with short edition. Measurement
is continued until next command or until an error occurs., like „h“.
Input:
H<cr>
Output:
WI31<cr><lf>
or @Exxx<cr><lf>
Remarks: Interface must be set to 9600 baud or higher to fully exploit the measuring
rate.
5.4 Set baud rate (N70N)
Function:
Set baud rate with fixed parity (None Parity) and fixed databits (8 databits).
Input:
N70N%1N<cr>
%1. Parameter: Baud rate:
1 600 baud
2 1200 baud
3 2400 baud
4 4800 baud
5 9600 baud
6 19200 baud
Output:
?<cr><lf>
(with old baud rate) or @Exxx<cr><lf>
Remarks: Settings are immediately stored in the EEPROM!
5.5 Back light on/off (LIGHT)
Function:
Switches LED on /off.
Input:
LIGHT %1<cr>
%1. parameter
0 Back light off
1 Back light on
Output:
?<cr><lf>
or @Exxx<cr><lf>
5.6 Delete display (CDISP)
Function:
Deletes display contents
Input:
CDISP<cr>
Output:
?<cr><lf>
or @Exxx<cr><lf>