Leica Geosystems Leica DISTO pro /pro4a - interface manual - Manual (Page 3)

3350-RUEA Error! Style not defined.
I:\DIST\Marketing\0Temp\Doc\interfaceManual111_en.docSeite 3 von 18 Erstelldatum: 17.06.03
1 O VERVIEW
This document describes the online set of commands for the DISTO
TM pro 4 and DISTO TM pro 4 a,
and its format which is available via the serial interface.
2 I
NTERFACE
2.1 Validity
The following firmware versions support these documented commands.
Firmware DISTO TM pro 4 / DISTO TM pro 4 a as of version 1.11 dated 15.06.2001
2.2 Parameters
The lay out of the interface of the DISTO
TM pro 4 / DISTO TM pro 4 a is such, that it can be con-
nected directly to a PC. The parameters of the interface are factory- set as follows:
Pro-standard: 9600 baud, none parity, 8 databits, 1 stopbit
These settings can be changed with the online commands.