Panasonic KX-E4500 - Manual (Page 235)

12-3 CAUTIONS
Be sure that the carrier stopper which holds the printer stationary during shipping is removed before
turning the unit on. Keep this stopper so that the unit can be transponed safely, if the need arises.
For the best possible operation of your typewriter, do not use a power outlet which is presently
being used for a copier or other device which consumes a large volume of power.
Do not use your typewriter in the following environmental conditions:
• In direct sunlight where additional heat will be generated.
• In areas where the atmosphere is extremely salty or where corrosive gases are present.
• On surfaces that are not flat, or subject to vibration.
Batteries
Cleaning
If improperly used, the batteries may leak and cause corrosion.
Therefore, observe the following:
• Insert batteries properly so that the polarity matches the plus
(+) and minus (—) positions indicated in the bottom of the
battery compartment.
• Do not use new and old batteries together.
• Do not use batteries of different types together. Some batteries
differ in voltage, even though they have the same shape.
• Do not attempt to recharge the batteries.
Use only a soft, dry cloth to clean your typewriter. Water or
thinners may damage the cover, case, or electronic circuitry.
Handling Disks
Never touch the magnetic material inside the plastic cartridge.
Never expose to magnetism (telephones, loud speakers and little
kitchen magnets).
Cables
Both, the Serial interface (KX-EISl) and the Parallel interface
(KX-EIPl), require a shielded cable less than 6 feet in length.
225