Installation of auto iris lens connector – Panasonic WV-CPR650 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation of Auto Iris Lens Connector
Install the lens connector (YFE4191J100) when using a
video drive ALC lens.
The installation should be made by qualified ser
vice personnel or system installers.
(1) Cut the iris coritrol cable at the edge of the lens
connector to remove the existing lens connector
and then rennove the outer cable cover as shown
in the diagram below.
The pin assignment of the lens connector is as fol
lows:
Pin 1: Power source; +9V DC, 50mA Max.
Pin 2: Not used
Pin 3; Video signal; 1.3 V[p-p]/40 kQ
Pin 4: Shield, ground
Pin 4
(2) After connection, assemble the lens connector as
follows.
Note: When the iris control cable is too thick to
lock the connector cover with the connector
base, cut off the rib on the connector.
(Select VIDEO for LENS DRIVE of the CAM
SET UP menu.)
-11-