Panasonic KX-F2350NZ - Manual (Page 19)

--i ' - > ./ j
*-• ‘ ■-. ' ■ -
A* A ^'.■ :-t^. ,* .. ■
Instructions for KX-F2450NZ users:
b r
3
^ lower guide plate
O/S^o
insert the leading edge of recording paper
between the upper guide plate (green plate) and
the lower guide plate. Then pull the paper a few
centimeters out of the unit.
4 Close the paper compartment cover carefully by
pressing down on both ends gently.
When the unit is on, the recording paper will
project itself slightly and be cut automatically.
NOTES;
• Use only the Included roll or specified recording papers (Part No. KX-A101 and KX-A106) for
supplement or else the print quality may be affected or excessive thermal head wear may occur.
•To install the KX-AI01 or a recording paper with V 2 inch core, you should use the included paper
roll holders for paper curl reduction system as shown below.
Fix the paper roll holders on both sides of the
recording paper roll.
Insert the left projection of the paper roll holder into the
left groove on the unit then the right projection into the
right groove, while pushing the paper roll to the left.
Follow the procedures from Steps 3 to 4 to finish
installing a KX-AI 01 or a recording paper with V
2 inch
core.
• If the recording paper is heavily curled, the paper curl reduction system may not function properly.
• Replace the paper roll with a new one:
— when the red lines appear on both sides of the recording paper.
— when the PAPER OUT indicator lights.
— when the display shows “E-06".
1-11