Clarion VRX766VD - Manual (Page 29)

Basic Operations
29
VRX766VD
English
Owner
’s ma
nua
l
Switching CONNECT (connect)
Make the following settings when an external
device is connected to the Visual terminal.
Setting the Blink LED
You can set the unit to blink the LED indication
when the DCP (Detachable Control Panel) is
removed.
Performing the system check
Setting the Auto Panel
When you remove or attach the DCP
(Detachable Control Panel), you can set the
liquid crystal panel automatically housing or
opening.
* The factory default setting is “ON”.
Setting the time of air conditioner
operation mode
This setting can be used to adjust the time the
panel stays in the horizontal position when in the
air conditioner operation mode.
* The factory default setting is 10 seconds.
NAVI :
when a navigation system is connected.
* When the navigation system is connected, use the
monitor lock function. Locking the monitor locks
the screen size in F.WIDE mode (full wide) and the
VTR system to NTSC.
OTHER :
for external devices other than a navigation
system.
NONE :
when no external device is connected.
* The factory default setting is “NONE”.
2-1. Touch the [NAVI], [OTHER] or [NONE] key
of the CONNECT item to set the function to
“NAVI”, “OTHER” or “NONE”.
2-1. Touch the [ON] or [OFF] key of the BLINK
LED item to turn the function on or off (The
factory default setting is “OFF”).
2-1. Touch the [ ]] key of the SYSTEM CHECK
item.
The available operation mode is listed in
white letters.
2-2. Touch [Check] key at the top right of the
screen to perform the system check
manually.
The system will be restarted after
performing the system check.
2-1. Touch the [ C] key to display the next menu
screen.
2-2. Touch the [ON], [OFF] or [CLOSE] key of
the AUTO PANEL item to set to “ON”, “OFF”
or “CLOSE”.
ON :
The liquid crystal panel houses
automatically after removing the DCP.
And the liquid crystal panel opens
automatically after attaching the DCP.
OFF :
Normal operation.
CLOSE :
The liquid crystal panel houses
automatically after removing the DCP.
2-1. Touch the [ C] key to display the next menu
screen.
2-2. Touch the [5s], [10s] or [30s] key of the
HVAC MODE item to set the time to “5
seconds”, “10 seconds” or “30 seconds”.
280QC6823KA_00.0_EN.book Page 29 Monday, February 27, 2006 9:22 AM