Clarion VRX766VD - Manual (Page 59)

59
VRX766VD
English
Owner
’s ma
nua
l
5.1 ch Surround Decoder Operations
This function is available when an optional 5.1 ch
Surround Decoder (DVH940) is connected.
When the 5.1 ch Surround Decoder is connected
through the CeNET cable, the 5.1 ch Surround
Decoder Control unit (DVC940, optional) cannot
be used.
5.1 ch Surround Decoder control
function
This section describes operation procedures of
setting functions.
For details on each functions, refer to the owner’s
manual supplied with the 5.1 ch Surround
Decoder.
* Requires an optional amplifier.
Note:
• The 2-ZONE mode is disabled when the DVH940
is connected.
1. Press the [ADJ] button to display the ADJUST
menu.
2. Touch the [AUDIO EXT.] key.
3. Perform setting for the desired item.
See the following sections for details.
4. Touch the [Back] key to return to the previous
screen.
* In the following sections, only the details
regarding settings are described, procedures
to select setting items are skipped.
●SPEAKER SEL (speaker selection)
This function determines center speaker,
surround speaker and sub woofer connection.
●Dolby PL II CONTROL
* This function is available only when the MUSIC
MODE is selected for Dolby PL II. For setup
details, see “Selecting the Dolby PL II (Dolby
Pro Logic II) type”.
3-1. Touch the [ ]] key of the SPEAKER SEL item
to show the submenu.
3-2. Touch the [ON] or [OFF] key of the CENTER
SP, SURROUND SP or SUB WOOFER item
to turn speakers on or off, depending on
what speakers are connected.
• The factory default setting is “ON”
• The phase of the “SUB WOOFER” is
reversed in the “ON-” setting. The default
value is “ON+”.
3-1. Touch the [ ]] key of the Dolby PL II CONT.
item to show the submenu.
3-2. Perform setting for the PANORAMA,
DIMENSION or CENTER WIDTH item.
[PANORAMA]:
Touch the [ON] or [OFF] key to select. “OFF”
is the default value.
[DIMENSION]:
Touch the [
[] or []] key to adjust the level
between 0 and 6. The default level is “3”.
[CENTER WIDTH]:
Touch the [
[] or []] key to adjust the level
between 0 and 7. The default level is “3”.
280QC6823KA_00.0_EN.book Page 59 Monday, February 27, 2006 9:22 AM