Panasonic PV-V4621 - Manual (Page 10)

Initial Setupfor DSS/Cable Box-VCR-TVConnection
How to Connect
2
Connect the OUT Jack on your cable box to the IN FROM
ANT. terminal on the VCR with an RF cable.
Connect the OUT TO TV terminal on the rear of VCR to the ANT.
IN terminal on TV using the RF Cable (included accessory).
How to do Initial Setup
1
2
Press VCR* button for VCR
mode. Turn the TV on and set it
to channel 3.
Turn VCR on.
When VCR is turned on the first
time, SELECT LANGUAGE screen
appears.
3
SELECT L anguage
PRESS CH A ; ENGLISH
OPRIMIR CH ▼ : ESPAÑOL
APP. VCR/TV : FRANÇAIS
TO CHANGE VCR' S OUTPUT
CH. PRESS ACTION KEY.
Press CHA to select English,
or
Press CHT to select Spanish,
or
Press VCR/TV key to select French.
When one of above keys is pressed,
SELECT CONNECTION screen is
displayed in the selected language.
• If screen does not appear, check
connection between VCR and TV
and, if TV is tuned to channel 3, try
switching it to channel 4.
• When you want to change the output
channel of VCR, please refer to VCR’s
Output Channel on page 13.
• If wrong language is set, do “Reset All
VCR Memory Functions” steps on
page 9.
WARNING--------------------------------------------------
4
VCflfC/A I CLOCK I CHANNEL
SELECT CONNECTION
VCH TV
VCR.CABLE/DSS BOX FT V
SELECT:* ▼
EXIT
: ACT I ON
Press A T to select “CABLE/DSS
BOXP-VCR^TV" connection and
press ► to set.
When using “Nut type" RF coaxial cables, tighten with fingers
only. Overtightening may damage terminals.
VCRÍ c TA TCLOCK I CHANNEL
■S elect connection
CABLE/OSS BOX .VCR MV
CABLE/DSS BOX OL/TPLiT CH
SELECT:* * SET;*
EXIT : ACT I ON_______
10
For assistance, please call : 1-800-211-PANA{7262) or send e-mail to ; [email protected]