Panasonic PV-V4621 - Manual (Page 19)

Important: li a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
Auto VCR Plus+ System Channel Setup (Part 2)
Before you perform the following steps, you
should have:
• completed “Auto VCR Plus+ System Channel
Setup (Part 1)” on page 18.
• left VCR off overnight, and turned it back on after
9:00 AM the next day.
1 . If channel updating was It VCR could not
successful... distinguish channel map.
fVCH fC/A ICLOCK 1 CHANNEL ivcHic/A ICLOCK 1 channel
VCR Plus* CH SET please select
COMPLETED VCR PkjJ* CHANNEL
:ACTION
J1EXT ;ACTION
Press ACTION
to exit this mode.
Press ACTION
to display SELECT VCR
Plus+ CH.
Continue with step 2.
rvcH icM fcCbCK J channel I
101 09 110
SELECT
SET
EXrr
:ADD/DLT
: ACTION
Press AW ► to select
channel map for your
area and press ADD/
DLT to set.
VCRTC/A I cl OCK I CHANNEL
please leave VCR OFF
OVERNIGHT
END : ACT I ON
Press ACTION
to end.
Make sure to leave
VCR off (overnight.)
Channel map will be updated (overnight.)
If it was successful, "VCR Plus+ CH SET
COMPLETED” appears on screen. And then,
press ACTION to exit.
Repeat these steps as necessary.
If Auto Setup fails, do “Manual VCR Plus+ System
Channel Setup” on page 20.
SELECT/
SET
A :PLAY
T .STOP
◄ :REW
► :FF
ACTION
ADD/DLT
To Change or Update Auto VCR
Plus+ System Channel Setup
(E.g. you selected wrong channel
map or zip code.)
a Do “Auto VCR Plus+ System
Channel Setup (Part 1)” steps
1-4 on page 18.
rvCRlC/A i^dCK i channel
SELECT VCR Plus- CH
SELECT:A w SET:*
EilT_;AÇTfON__
b Press AT to select UPDATE VCR
PIUS+or SELECT VCR Plus+CH,
thenpress*-.
c If you selected UPDATE VCR Plus+
CH. perform steps5-7 in the “Auto
VCR Plus+SyslemChannel Setup
(Part 1)” section on page 18,
If you selected SELECT VCR Plus+
CH. perform steps 2-3 in the “Auto
VCR Plus+ SystemChannel Setup
(Pa rt 2)” section on th is page.
19