Panasonic PV-V4621 - Manual (Page 17)

'Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1 VCR Phis+ 1 PROG. kUST
P DT START STOP CH SPD
1 7 9;OOA12:OOA 08 SP
2 8 1O;OOP12:0OP 02 SP
3 w S;00P OiOOP 10 SP
4 SU 9:OOP10:OOP LI LP
▼
SELECT:* ▼ * ►
EXrr
: PROG
1) Press
PROGA^CR+ button.
2) Press
to select LIST;
P nr START STOP CH SPD
8 10:00P12:0№ 02
10 8:00P 9:00P 10
SU 9:OOP10:OOP LI
CANCEL lADD^DLT
SELECT :A V SET;^
EXIT :PROG
Press AT
to select number.
1 VCR Ph)S+ fWOO I
IDATE START STOP
CATEGORY: N/A
SELECT START DATE
SELECT:* t SET:* k>
END :PROG
1) Press ►
to display.
2) Repeat steps
(pg.16) to set
new programs.
or
To Clear program...
VCR PIUS+ I prog / I LIST
'P OT START STOP CH SPC
2 8 10:OOP 12:00P 02
3 10 8:OOP 9:00P 10
1 SU 9:00P10:00P LI
CANCEL :ADD/DLT
SELECT :A T SET:►
EXIT : PROG
I Press ADD/DLT.
To cancel a Timer
Recording in progress...
Press POWER and then STOP
within 10 seconds to cancel the
Timer Recording. (The TIMER
indicator goes out on Multi
Function Display.)
3 To Replace program...
Press PROG/VCR+ button
to end the program.
• If there are set programs, press
POWER off to set timer.
SELECT/
SET
A :PLAY
▼ :STOP
◄ :REW
► :FF
PROG/
VCR+
ADD/DLT
- Important notes when using a DSS receiver —
When recording programs via a DSS receiver, the DSS
receiver must be left on.
When recording programs via an antenna or cable, the DSS
receiver must be turned off.
17