Panasonic PV-V4621 - Manual (Page 9)

‘Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
5 Press CHA Key to start Channel/Clock
Auto Set operation. Settings are
performed automatically. If the setup is
completed, the following screen is
displayed.
vcn C/A_rCL00T1 Ch
5/13/2001 SUN 2:20PM
DSTiON
SemiMG : CH 10
!CH UP KEY --------- I
If “Auto Clock Set is Incomplete"
screen appears, set the clock using
MANUAL CLOCK SET procedure
shown below.
VCH I C/A I CLOCK ! CH
AUTO CLOCK SET IS
INCOMPLETE
PLEASE SET CLOCK BY
PflESSlNG ACTION KEY
POWER
VCR
VCR/TV
SELECT/
SET
A :PLAY
▼ :STOP
◄ :REW
► :FF
ACTION
CHA/W
Manual Clock Set
If Auto Clock Set was incomplete, manually
set the clock as follows.
1
Press ACTION Key on the Remote to
display CLOCK Menu screen.
I VCR I C/A~ I CLOCK I ~CH~j
2
SELECT MONTH
SELECT:A t SET:
-EXII____TACTION_____
Press A T to select the month and ►
to set. In the same manner, select and
set the date, year, time, and DST
(daylight saving time).
3
f VCR I C/A I CLOCK I ^CFTI
11/11/2001 SUN 12:OOPW
DST. ON
SET COMPLETED
SET p
START : ACT I ON
Press ACTION Key twice to start
CLOCK and exit.
Reset All VCR Memory Functions
Use when moving VCR to new
location, or if a mistake was made in
the Initial Setup section.
• Make sure a tape is not inserted in
the VCR.
PLAY and CHANNEL
▲ on the VCR for
more than 5 seconds.
• The power shuts off.
Do “Initial Setup” on page 8.