Panasonic PANAFAX UF-550 - Manual (Page 133)

Relayed Transmission ^
Setting Up Your Machine for Relayed Transmission
To set up your machine for Relayed Transmission, use the procedures on the following pages to set the
parameters listed below. Some parameters (e.g., Relayed XMT FAX Parameter) are only set once, but others
must be set separately for each station in the Relay Network.
1. Relayed XMT Request FAX Parameter
This switches the Relayed XMT Request function to Valid or Invalid.
2. Own Telephone Number
The full telephone number to which the machine is connected should be entered for Relay Station send
back Result Report.
3. Own Network Address
A 4-digit Own Network Address should be entered for Relay Station send back Result Report.
4. Network Password
A 4-digit number which prevents unauthorized (outside) stations from accessing the Relay Station and
using its memory. Every Relay requesting and Relay stations in the network should set the same Network
Password.
5. One-Touch/ABBR Numbers
The One-Touch or ABBR number you set must represent the fax number of a particular station in the
network as seen from your station.
1) Network Address
End Receiving Station telephone numbers set in an Initial Sending Station may be different from the
numbers set in a Relay Station. To send a fax to an End Receiving Station via a Relay Station each
station in the network must be identified with a certain code which does not vary depending on where
you call from. The code is the Network Address, which consists of a 4-dlgit number and is assigned
to a One-Touch/ABBR number.
2) Relay Address
A 2-digit number which identifies the Relay Station your machine will use. Your machine may be
connected to more than one Relay Station in parallel, but when you use Relayed XMT Request your
machine will only send documents to the Relay Station identified by the Relay Address.
3) Relay Station Parameter (Yes/No)
Set ”Yes” if the particular station you are recording is a Relay Station. If you are connected to more
than one Relay Station in series, set "Yes” only for the first Relay Station.
4) One Station XMT (Relay/Direct) Parameter
If you send a document to only one End Receiving Station, you can set your machine to transmit directly
to that station, without going through the Relay Station, by selecting "No”. Set "Yes” if you always want
to go through the Relay Station.
131