3 check that the [auto check] lamp is flashing – Panasonic LUMIX DMW-FL360 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
*ress the [MODE] button, and
elect the flash mode. (P19)
> The flash working range is
shown on the display panel in
line with the settings of the
digital camera.
3 Check that the [AUTO
CHECK] lamp is flashing.
AUTO CHECK
i n
: >
iLLL. :
3
Flash working range
I Check that the distance
to the subject is within
the flash working range.
> If the subject is outside the
range, adjust the aperture of the
lens or change the distance to
the subject.
^ The flash working range
changes depending on the type
and settings (ISO sensitivity,
aperture and focal length) of the
digital camera used.
I
Press the shutter button
all the way down, and
take the picture.
® If the [AUTO CHECK] lamp
continues to flash for about
5 seconds, it means that the unit
has fired successfully. If it does
not flash, the unit has not fired
successfully. Check the settings
on the unit and the digital
camera and then take the
picture again.
21
VQT1B10