Clarion Platinum Sound Processor - Manual (Page 24)

Using the CLARION Platinum Sound Processor 19
V. Using the CLARION
Platinum Sound Processor
Getting Started
In order to use the Processor, follow the steps below:
1. Verify that the Processor program switch is in the off (o) position.
2. Check that a charged battery or an AA battery pack has been
correctly mounted onto the Processor.
3. Adjust the volume ( ) so that the indicator notch on the
control is all the way to the left.
4.
Check the position of the sensitivity control ( !
!
!
!
! ) so that the
indicator notch on the control is to the left of the midpoint at the
10:30 position.
5. Check that the headpiece connector is properly plugged into the
headpiece jack on the Processor.
6. Place the headpiece on the head over the implant.
7. Turn the Processor on by turning the program switch to the
appropriate position (as determined by your clinician). Note that
the red LED indicator should blink at least once.
8. Verify that the red LED indicator on the Processor stops flashing
once communication is established with the implant.
9. Readjust the volume and sensitivity controls as necessary.
Adjustment of the controls may vary throughout the day
depending upon the listening environment.
IMPORTANT: Use only the Processor that has been programmed
especially for you. Using a different Processor, which has been
loaded with a different program, may be ineffective in