Yamaha RX-V1065 - Manual (Page 24)

Optimizing the speaker setting for your iistening room (YPAO)
If an error is detected during measurement, the
measurement is canceled and “Error” appears on the GUI
screen. Check the error and solve the problem. For details
on each error message, see page 75.
Press HCursor V once, press HCursor < 1 / 0
to select “Retry” or “Exit” and then press
QIENTER.
FrontiyR channel signals are not detected.
Check wiring and connections of the front L/R speakers.
Retry
Performs “Auto Setup” again.
Exit
Terminates the measurement and “Auto Setup”.
• When "E-5:N0I.SY" appears, you can continue measuremenl. To
continue measurement, select “Proceed”. However, we recommend that
you solve the problem first and then perform measuremenl again.
If a problem occurs during measurement, “Check xx
warning(s)” appears on the GUI screen. Check the
warning and solve the problem. For details on each
warning message, see page 76.
SpeakerC
lance {Min/
Level (Min/
3/4/0.1
8.0ft/8.5fl
-3.5dB/+4.5dB
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform “Auto
Setup” again.
1 Press HCursor V / A to select “Check xx
warning(s)” and then press QIENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using HCursor l>.
2
To return to the top result display, press
QIENTER again.
21 En