Panasonic NV-HD70EA - Manual (Page 23)

Timer Recording
G-Code Programming
Programming is now easier than ever: simply enter the
G-Code number provided in the programme schedule
column carried by newspapers and magazines,
G-Code numbers are numbers which are assigned to each
programme listed in the TV programme schedule carried in
newspapers and TV guides. When these numbers are
entered and
TRANSMIT is pressed, the numbers are
converted into the actual programming and sent to the VTR.
4
2
5
4
3
Preparation
• Insert a cassette tape with an intact erasure prevention
tab.
• Set the programme positions on both the VTR and remote
controller as shown on pages 8-11.
Operations Display Symbols
Open the door of the remote controller
Press G-CODE.
raggi
Enter a G-Code number.
Example: 920216
c j m I f
J L UL i i J
Press CONFIRM to check that the
number corresponds to the right
programme.
CD
• If the display looks like this
z A:
SU
D ON OFF
n 1 Ml m 11*1 rr
1 1 ( j lU IJ JJ
su
0 ON OFF i lO' fH in rr
J i J H i ij JJ
then please check “Preparations for G-Code
Programming" on pages 10 and 11. The TV
station selected by identification number and VTR
tuning position have not been correctly set up m the
remote controller,
•To make any corrections, use buttons O'*©-
Press TRANSMIT.
Close the door of the remote controller.
Notes:
•To select the desired tape speed, press RECORDING
SP/LP in any of steps 3-4.
• When the G-Code number is used for programming, the
recording time may be slightly longer than the actual
programme time.
• Repeat steps 2 to 4 if “Err" appears on the remote
controller,
• When programming two or more programmes, repeat
steps 2 to 5 after pressing TRANSMIT.
•The procedures for checking and cancelling whatever has
been programmed are the same as for remote control
programming.