Panasonic OMNIVISION PV-8401 - Manual (Page 25)

^Important: If the remote control POWER, ACTION, PROG, CHA/T , INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
if you are using a cable box and it is connected to your VCR in one of the ways shown in Connection Type A
on page 24, you will need to complete the Cable Box Setup steps below.
2
3
4
Cable Box Setup
Complete this page only if Type A
connection method (pg. 24) is used.
1
Press ACTION* to display
the menu. --------------- MENU ---------------
SET UP VCR
SET CLOCK
Press AT
to select “SET UP
CHANNEL," and then press
► to display the “SETUP
CHANNEL” screen.
SET UP CHANNEL
ID IOMA/ LANGUE: ENGL1 SH
SELECT:* ▼ KEY
SET ;► KEY
END : ACT I ON KEY
Press AT to select “CABLE/
DSS BOX SET UP," and
then press ► to display the
“SELECT HOOKUP" screen.
------ SET UP CHANNEL
AKTENNA ; CABLE
AUTO SET
CABLE/DSS BOX SET UP
VCR PluS+ CH SET UP
SELECT:* ▼ KEY
SET :► KEY
END :ACTION KEY
Press AT
to select your hookup,
and then press ► to set.
• If you selected CABLE/DSS BOX^
VCR^TV, continue with step 5.
If not, press ACTION three times
and turn to page 26.
SELECT HOOKUP
CABLE/DSS BOX>-VCRHV
VCft^CABLE/DSS BOX^TV
VCRI-TV
SELECT:* ▼ KEY
SET ;► KEY
END : ACT ION KEY
Press AT
to select your cable
box or DSS receiver output
channel number, and then
press ► to enter. ■
• If necessary, refer to your cable
box manual.
• If you are using Audio/Video jack
connections to your cable box,
select and set “VIDEO OUT” as
the output channel.
SELECT HOOKUP
CABLE/DSS BO»VCR>-TV
CABLE/DSS BOX OUTPUT CH
SELECT;* T KEY
SET :•* ► KEY
END ¡ACTION KEY
6
Press ACTION twice to end the setup and return
to the normal screen.
Go directly to '*VCR Plus+ Programming” on page 27.
r
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar
Development Corporation.
25