Answering machine & telephone, Cause & remedy, Some voice-messages have not been fully recorded – Panasonic KX-F220 User Manual
Page 113: The unit does not ring
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ANSWERING MACHINE & TELEPHONE
PROBLEM
When the Call-Counter shows “—
CAUSE & REMEDY
•A power failure has occured, confirm whether the voice
messages are recorded on the tape or not.
•The ICM tape is not rewound after the unit is turned on.
The unit does not work when I press buttons.
Turn the POWER switch off, then turn it on again.
The unit has been set to the Auto Receiving
mode, but no voice-messages have been
recorded.
•The tape is broken (cut, worn out or twisted) or not installed.
•Change the FUNCTION selector to the ANS/FAX position.
When the tape is played back, the sound ievel
«Raise the sound level using the SPEAKER VOLUME control,
is lower and nothing is heard.
«Clean the head. See “MAINTENANCE” on page 30 in
INSTALLATION MANUAL.
I have played back all the recorded messages
Leave the unit as it is after hearing the messages.
and I want to record the next call after the last
message
I cannot retrieve recorded messages from a
«Make sure that you use your own ATAS ID number,
remote phone.
«When you press your ATAS ID number, press firmly.
Some voice-messages have not been fully
recorded.
When the caller hangs up after leaving
message, the tape does not stop.
The unit does not ring.
The caller suddenly cannot hear my voice
during a conversation.
Set the CPC to“B”.
Vox detect time should be set to 4 seconds.
Set the RINGER VOLUME selector to the HIGH or LOW
position.
Look at the MUTE indicator. If it is lit, press the MUTE button to
resume the conversation.
4-4