Suggestions for safety, Before use – Panasonic SC-CH7 User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Suggestions for Safety

■ Use a standard AC wait outlet

1. Use from an AC power source of high voltage, such as for

an air conditioner, is very dangerous.

There is the possibility that a fire might be caused by making
such a connection,

2. A DC power source cannot be used.

Be sure to check the power source carefully, especially on a
ship or other place where DC is used.

■ Grasp the plug when disconnecting the power

suppiy cord

1. Wet hands are dangerous.

A dangerous electric shock may result if the plug is touched by
wet hands.

2. Never place heavy Items on top of the power supply cord,

and never force It to bend sharply.

■ Place the unit where It will be well ventilated

Place this unit at least 10 cm (4") away from wall surfaces, etc.

■ Avoid places such as the following:

In direct sunlight or In other places where the temperature Is

high.
In places where there Is excessive vibration or humidity.

Such conditions might damage the cabinet and/or other component
parts and thereby shorten the unit’s service life.

■ Be sure to place the unit on a flat, level surface

If the surface is inclined, a malfunction may result.

■ Never attempt to repair or reconstruct this unit

A serious electric shock might occur if this unit is repaired,
disassembled or reconstructed by unauthorized persons, or if the

internal parts are accidentally touched.

■ Take particular care If children are present

Never permit children to put anything, especially metal. Inside this
unit. A serious electric shock or malfunction could occur if articles
such as coins, needles, screwdrivers, etc. are Inserted through the
ventilation holes, etc. of this unit.

■ If water is spilled on the unit

Be extrerrrely careful if water is spilled on the unit, because a Hre or
serious electric shock might occur. Immediately disconnect the
power cord plug, and consult with your dealer.

■ Avoid spray-type insecticides

Insecticides might cause cracks or "cloudiness” in the cabinet and
plastic parts of this unit. The gas used in such sprays might,
moreover, be ignited suddenly.

■ Never use alcohol or paint thinner

These and similar chemicals should never be used, because they

might cause flaking or cloudiness of the cabiriet finish.

■ Disconnect the power supply cord If the unit

will not be used for a long time

If the unit is left for a long time with the power ON, this will not only
shorten its useful operation life, but may also cause other troubles.

■ If trouble occurs

If, during operation, the sound is interrupted or indicators no longer
illuminate, or if abnormal odor or smoke is detected, immediately

disconnect the power cord plug, and contact your dealer or an
Authorized Service Center.

Before Use

Be sure to disconnect the mains cord before adjusting the voltage

selector.

Use a minus (-) screwdriver to set the voltage selector (on the rear
panel) to the voltage setting for the area in which toe unit will be
used.

(If the power supply in your area is 117 V or 120 V, set to the

"110-127 V" position.)
Note that this unit will be seriously damaged if this setting is not

made correctly. (There is no voltage selector tor some countries;

the correct voltage is already set.)

THIS TUNER/RECEIVER IS CAPABLE OF RECEIVING THE NEW AM STEREO BROADCASTS FROM THE AM BAND

RADIO STATIONS. HOWEVER LIKE MANY TUNERS AND RECEIVERS CURRENTLY AVAILABLE ON THE MARKET
IT WILL REPRODUCE THIS AM STEREO SIGNAL ONLY IN AM MONO. WHICH, IN EFFECT, IS OF NO LESSER

QUALITY THAN YOUR EXISTING AM MONO TUNER/RECEIVER.

- 3 -

Advertising