Panasonic SC-CH7 - Manual (Page 43)

3 5
Editing with consideration to the specified tape length (TAPE LENGTH)
Like the "Sequencial editing" function on the previous page, this
function aiiows for automatic recording of CD songs in sequence,
on a tape whic^ you spedfy its iength.
Hovraver, at the end of each side of the tape, instead of fading out
the song, the tape is left biank unless the next entire song in the
sequence wiil fit.
A tape such as foiiows wiii be made;
{side A) I iBttrack 1 I 2nd track | | Srdlrack [ [ 4lhtrack J
(side B) I 5th track~^ | 6th track | 7th track [ |
1 Carry out the steps 1 and 2 of “Recording” on
page 40.
Recording witi take place automatically from the forward side
to the reverse side of the tape, so insert the tape with the side
from which you intend to record first facing toward you, then
enter the reverse mode
2 Press the input seiector button on the ampii-
fier marked “CD”.
3 Load a disc.
4 Press the edit mode button to seiect the tape
iength.
Each time the button is pressed the tape length indicator
changes as follows.
I—»[c^6]-»ic-60|
IC-AUTOi i
*------lC-90l
Remaining time on side A Remaining time on side B
•Cassette deck will take up the leader tape automatically and the
edit indicator wilt illuminate.
■ To specify a tape iength other than C-46 60,90
Press the edit mode button 5 times to select "C- Then press tiie
numeric button on the remote control transmitter to specify the total
recording time of the tape. From the main unit, keep pressing one
of the skip buttons until the display shows the desired tape length.
For example:
If a 52 minute tape is to be used, from the remote control
transmitter, after pressing the CD 10 KEY, first press 5, and then 2.
From the main unit, keep pressing (or press or hold) one of the skip
buttons (P-N, M^) until the display shows "C-52''.
5 Press the piay button.
The ATLS function (See page 45) will operate to adjust the
recording level and then recording will start.
Whoi edit-recording has finished, the cassette deck automatically
creates a non-recwded passage of about four seconds in length,
and then enters the recording standby mode.
•When you want to record programmed tracks, first program
tracks in memory using the progrwn play procedure. Then press
the edit mode button.
■ To record another disc on the tape left
(See page 45.)
^ m MM Mc wMe
""i a 3 4 s 6 |^T
Tracks edited on side A Tracks edited on side B
—Edit indicator
-43-