Selection of cassette tapes, To prevent erasure of recorded sounds, To re-record on a protected cassette – Panasonic SC-CH7 User Manual
Page 55: Avoid tape storage in the following places, About cassette tapes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
About Cassette Tapes
Selection of cassette tapes
Do not use the following types of tapes in this unît.
•120^inute (or longer) tape»
Because the tape is very thin, it might stretch during use causing
unstable tape movement which may result In the tape becoming
tangled in the rotating parts of this unit,
^
•Fe-Cr tapes (TYPE III)
The high frequency range will be emphasized and it viiil) not be
possible to obtain a fiat frequency response.
•Metal tape wHtiout detection holes In the cassette
Recordings will be very distorted. (There is no playback problem
however.)
Tape slack
Tape stack may cause the tape to break.
To prevent erasure of recorded sounds
Remove the erase-prevention tat» (thus preventing recording).
Tab for side “A'
Use a screwdriver
or similar object to
break out the tab.
Tab for side "8"
■ To re-record on a protected cassette
Cover the slot with adhesive tape.
Avoid tape storage in the following
places
Tape can be damaged if it is stored in places such as described
below.
•Where the temperature is high (ЭбТ/ЗбХ or higher) or where the
humidity is high (80% or higher).
•Where there is a strong magnetic field (near a speaker, on fop of
a TV, etc.). Recording may become erased.
•In direct sunlight.
-55-