Panasonic SC-CH7 - Manual (Page 31)

Memory Presettings
The indication AM used here includes
both MW and LW.
When broadcast frequencies have been preset to the menwry, any of those broadcast frequencies can thereafter be easily selected by simply
pressing one of the preset-tuning buttons. There are two methods for presetting broadcast frequencies in the memory: the automatic ntethod {see
below) and the manual method (refer to page 32); select whichever method you prefer.
If a new broadcast station is preset into a channel, the broadcast station which was previously entered in that channel will be automatically erased.
Automatic memory presetting
When this method is used, the frequencies of the selected
broadcast stations are automatically preset (in sequence to higher
frequencies) into the memory; “channels”
1 to 28 are available for
the presetting of FM stations, “channels" 21 to 28 are available for
MW stations, and “channels" 27 to 28 are available for LW
stations. When a presetting is made to a channel that has already
been preset, the prior presetting will be erased.
Carry out the steps 1 and 2 of “Standard Operations” on page
20.
1 Select the desired band (“FM”, “MW” or
“LW").
i n I o n
FM
I LJ I, LJ LJ
MHz CH.
Set to the frequency from which you want to
start automatic memory presetting.
(Refer to “Frequency tuning" at the right.)
Press and hoid the memory button; release it
when the display frequency begins to change.
(The memory indicator will flash, and the automatic memory
presetting is activated.)
FM LJ MHz CH.:
■ To confirm the stations which are preset to
each channel
Press one of the preset-tuning buttons.
The frequency preset Preset number
Notes:
•For automatic presetting in areas where there are fewer than 28
FM stations, the remaining channels (through channel 28) will be
left unoccupied. The unoccupied channels can be filled by using
manual memory presettings.
•For AM broadcasts with extremely strong signal transmissions,
the frequency memorized may be slightly different than ttie
correct frequency, if this occurs, make a manual presetting.
■ Frequency tuning (“TUNING” buttons)
1 ▼ TUNINGI Press to changa the frequency downward.
I A TUNING I Press to changa the frequency upwanJ.
1. Press and hold one of the tuning buttwis, then release the
button when the displayed frequency begins to change.
2. When the displayed frequency approaches the desired frequen­
cy, press one of the tuning buttons momentarily. (The displayed
frequency will stop changing.)
Note:
The changing of tiie displayed frequency will be automatically
stopped (by the automatic tuning functicm) if a broadcast station
frequency is located during the tuning process, if the frequency
at which it stops is not the desired frequency, repeat step
1
above.
3. After stopping at step 2, tap one of the tuning buttons a few
times until the desired frequency is reached.
■ MW allocation
When the band select button is pressed for about 3 seconds, the
MW frequency step will change to 10 kHz per step. (This unit Is set
to 9 kHz before shipment.) In order to return to the original
frequency indication, press this button for about 3 seconds again.
■ LW freq shift
When the bwid select button is pressed for about 3 seconds during
reception of an LW broadcast, the LW frequency will decrease by 2
kHz. In order to return to the original frequency indication, press
this button for about 3 seconds again.
-31-