ALFA NETWORK AWAP411 - Manual (Page 11)

AWAP411 150M Wireless 11N Access Point
1.3.2 The Rear Panel
Figure 1-2
Viewed from left to right, the following parts are located on the rear panel of AWAP411 .
Wireless antenna: The external antenna is used to transmit and receive wireless data.
POWER: The power port connects to the power adapter provided with the 150M Wireless 11N
Access Point .
LAN: One LAN 10/100Mbps RJ45 port connects to a network device, such as a switch or a router.
RESET: The Reset button is used to restore the AP’s factory default settings. There are two ways
to reset the Access Point’s factory defaults:
z
Method one: With the AP powered on, use a pin to press and hold the Reset button (about 5
seconds) until the System LED becomes quick-flash from slow-flash. And then release the
button and wait the router to reboot to its factory default settings.
z
Method two: Restore the default settings from “System Tools > Factory Defaults” of the
Modem's Web-based management page.
)
Note:
Ensure the AP is powered on before it restarts completely.
5