ALFA NETWORK AWAP411 - Manual (Page 24)

AWAP411 150M Wireless 11N Access Point
)
Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
2) Multi-SSID: This mode allows the device to support up to 4 SSIDs.
Figure 4-8 Wireless Settings in Multi-SSID mode
¾
Enable VLAN - Check this box and then you can change the VLANID of each SSID. If you
want to configure the Guest and Internal networks on VLAN, the switch you are using must
support VLAN. As a prerequisite step, configure a port on the switch for handling VLAN
tagged packets as described in the IEEE802.1Q standard, and enable this field.
¾ SSID (1-4) - Up to 4 SSIDs for each BSS can be entered in the filed SSID1 ~ SSID4. The
name can be up to 32 characters. The same name (SSID) must be assigned to all wireless
devices in your network. If Enable VLAN is checked, the wireless stations connecting to
SSID of different VLANID can not communicate with each other.
¾
VLANID (1-4) - Provide a number between 1 and 4095 for VLAN. This will cause the device
to send packets with VLAN tags. The switch connecting with the device must support VLAN
IEEE802.1Q frames. The wireless stations connecting to the SSID of a specified VLANID
can communicate with the PC connecting to the port with the same VLANID on the Switch.
¾
Channel - Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby access point.
¾
Mode - This field determines the wireless mode which the device works on.
• 11b only - Only 802.11b wireless stations can connect to the device.
• 11g only - Only 802.11g wireless stations can connect to the device.
18