Installing multiple 6416y2 cards – Aviom 6416Y2 User Manual
Page 17
To install the 6416Y2 card:
Start with the power to the Yamaha digital device
1.
off.
Remove the Yamaha device’s power cord from the wall receptacle.
2.
Remove the cover plate on the Yamaha
3.
device’s expansion slot to expose the expansion
connections.
Discharge any built‑up static charge by touching the metal casing of the host Yamaha unit.
4.
Remove the 6416Y2 card from its protective anti‑static sleeve.
5.
Ensure that the 6416Y2 card
6.
DIP switches are set properly for your application at this
time—the card can be programmed using its internal DIP switches or from the Pro64
Network Manager software.
Slide the 6416Y2 card into place, aligning the sides of the card with the support guides in
7.
the MY expansion slot.
Press the 6416Y2 card firmly in place to attach the multi‑pin connectors on the card to
8.
those on the expansion slot backplane on the Yamaha device.
Tighten the thumb screws on the 6416Y2 to secure it.
9.
Power up the Yamaha digital device.
10.
Connect the 6416Y2 to a Pro64 network.
11.
Once the 6416Y2 card has been configured and is installed in the Yamaha host device, all signal routing to/from the
6416Y2 A‑Net Interface Card for processing and/or mixing is done from within the Yamaha device’s user interface.
Consult the documentation that came with your Yamaha product for more specific signal routing information.
P
N
ote
:
Always power off the Yamaha host device before removing the 6416Y2 card.
Installing Multiple 6416Y2 Cards
A Yamaha host device can support as many Pro64 A‑Net cards as it has available MY (mini‑YGDAI) expansion slots
and internal power resources. When multiple 6416Y2 A‑Net Interface Cards are installed in a Yamaha host device,
each 6416Y2 card needs to be connected via its A‑Net ports to the Pro64 network. Simply use a short Cat‑5e
jumper cable to interconnect the 6416Y2 cards.
A list of compatible Yamaha products and the number of available MY expansion slots on each appears on
page 4.
P
N
ote
:
Remote mic preamp control for Pro64 devices from the Yamaha user interface is available using
m‑control. Some Yamaha devices (including the LS9 series) require that the card sending remote control
data be installed into the console’s MY expansion slot #1.
7
I
nstallInG
the
6416Y2 c
ard