Aviom 6416Y2 - Manual (Page 48)

c
oNFiguriNg the
6416Y2 c
ard
The diagrams below details the functions of the 6416Y2 card’s DIP switch blocks on the front panel and circuit
board that will be used in the configurations that follow.
ON
ON
ON
ON
ON
ON
SW7
SW8
SW3
SW9
SW4
SW1
SW2
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Transmit Slots (from console)
Transmit Port
Front Panel
Managed Mode
Control Source
Receive Slots (to console)
Receive Port
MY16/MY8 VDC
Channel Activation (1-8)
Channel Activation (9-16)
Remote Control
Mode
VDC
6416Y2 card showing the functions of the various DIP switches; the arrow indicates SW7, on the front of the card, shown below.
(DIP switch handles are indicated in black.)
Control
Master Remote
Control
6416Y2 set as Control Master
Choose a Control Master
The first step in setting up a Pro64 network is to decide which Pro64 device will be the Control Master. A Pro64
network always has one Control Master and one Clock Master. The Control Master is in charge of network‑wide
settings, channel/Slot management, Virtual Data Cable allocation, error messaging, etc. The Clock Master controls
the network sample rate and can allow the use of external word clock sources if 6416dio Digital I/O Modules or
AllFrame devices are part of the network. Any I/O device can be the Control Master, but only one Pro64 device
may be in control of the network at a time.
38 c
onfIGurInG the
6416Y2 c
ard