COP-USA CD55NV-HD22 - Manual (Page 22)

- -
= > , @\+,-. / etc.
Ø Clear header: Clear preset header setting.
Ø Return to the previous menu.
Ø AUTO SCAN: to enter the Auto Scanning submenu
Ø SCAN NO: to set the auto scanning number, maximum is 03.
Ø SPEED: to set the scanning speed for each patrol.
Ø SET START LIMIT: to set the start position of the scanning. After the user enter this item,
to use the joystick to move the dome camera and press “CLOSE” to save the current
position.
Ø SET END LIMIT: to set the end position of the scanning. After the user enter this item, to
use the joystick to move the dome camera and press “CLOSE” to save the current
position.
Ø RUN SCAN: to run the scanning function, Please set the start and end position first. And
if the start and end position are the same. The dome camera will
scanning for 360 To press “CLOSE” to exit.
Ø CLEAR SCAN: the clear the setting of the scanning, to press
“CLOSE” to exit.
Ø RETURN: to return to the MOTION SETUP menu.
Ø PATROLS: to enter the submenu to set the patrols.
Ø PATROL NO: to set the patrol number.
Ø EDIT PATROL: to set the parameter of the patrol, after enter this
item, the monitor is as following:
Both top and bottom lines display prompt and information of each patrol is displayed on
1.< PRESETS >
2.
AUTO SCAN
3. PATROLS
4. PATTERNS
5. SCHEDULE
MOTION SETUP
6. CLEAR
7. EDIT DOME LABEL
8. RETURN
1. PATROL NO : 001
2. EDIT PATROL
3. RUN PATROL
4. CLEAR PATROL
5. RETURN
PATROLS