COP-USA CD55NV-HD22 User Manual
Page 30
-
-
4. Setup of the Baud Rate of Communication.
As shown in Figure 2, SW2 is used to set
the protocol of communication and the baud rate used by the dome camera. DIP-6 and
DIP-5 of SW2 are used to select the baud rate of communication and 4 different baud
rates can be selected in maximum. If the controller adopts non-standard baud rate, you
can adjust it to be identical with that of the main machine as per the following table.
Baud Rate of Communication
DIP-1
DIP-2
DIP-3
DIP-4
Setup of Baud Rate
DIP-5
DIP-6
2400 bps
OFF
OFF
4800 bps
ON
OFF
9600 bps
OFF
ON
19200 bps
ON
ON
5. Selection of the Terminal Resistor of the Dome Camera.
As shown in Figure 2, JP1
is the select switch of the 120 Ω terminal resistor on the bus RS485, on which
only one terminal resistor of the dome camera at the farthest end can be connected, while
the terminal resistors of other devices should be opened.
6
shortcut control function
to ON/OFF the mode of shortcut
Set Preset
Call Preset
Reserved
Tow Preset Open the menu
Reserved
Open the menu
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved