COP-USA CD66MK-HW - Manual (Page 24)

- 21 -
e)
Finally fix the camera bottom pedestal board and camera connecting board with M3
Screw.
3) Steps of outdoor wall Installation.
a) Unpacking the carton and carefully take out the dome camera and its attachment.
b) Take out of the dome, and put three pieces of fast-fixed screws into the fixing hole,
rotate it towards the clockwise direction until it’s tighten. Finally fix the camera
bottom pedestal board and camera connecting board with M3 Screw
（Figure13）.
Figure13
d
） Drill some holes on the wall according to the bottom fixed holes(Figure7)，then fix the
bracket on the wall
（Figure14）.
e
）Take out system control wires ,video wires, the power wires from the bracket
（Figure15）.
f) Fix the dome on the wall with screws
（Figure16）.
Figure 14 Figure15